Saltiga LD 35HS Spool + α Saltiga

This is a set of two units: one Saltiga LD35HS main unit and another for parts, including a spare spool and parts.
I purchased these as used items in good condition and used them only once for jigging. After that, I overhauled them with Bel-Hammer Gold Grease No. 2 and stored them.
Although it is an older model, the mechanism is in very good condition.

The spool has been modified so that it can be replaced by removing the body, similar to the star drag type, allowing only the spool to be swapped.

The unit for parts is missing a few bearings and screws, but it may be usable if replacement parts can be obtained.
Please consider it for parts only, as I have not confirmed its operation.
The brown parts are degraded grease, not rust.

The exterior body, including the main unit, has some minor scratches, but there is no major damage, and the internal parts are relatively clean.

The line will be removed before shipping.
Although the condition is very good, please purchase with the understanding that these are used items.

According to information from overseas websites:
Gear ratio: 7.1:1
Maximum retrieve length: 133cm
Weight: 669g
Capacity is just enough to fit approximately 300m of Yotsuba PE line #6.
Please note that this may vary depending on tension and manufacturer, so please consider it as a reference only.

Also, as these are listed on other sites, they may be suddenly removed. Thank you for your understanding.